Zinsser B‑I‑N® Advanced Synthetic Shellac Sealer, Clear

 PRODUCT APPLICATION:

Surface Preparation:  Surfaces must be clean, dry, sound and free of any contamination, mildew, rust or unsound coatings that may interfere with adhesion. If unsure, wash the surface with an appropriate cleaner or solvent and rinse thoroughly. 

WARNING! If you scrape, sand or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-Approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead. 

Application: For interior use only. Apply only when air, material, and surface temperatures are between 50-90ºF (10-32ºC) and the relative humidity is less than 85%. Thoroughly mix or shake to ensure any settled pigment is re-dispersed before using. If thinning is required, add no more than 10 ounces of water per gallon. In most cases only one coat is necessary to seal most surfaces. If excessive absorption occurs over very porous substrates a second coat may be necessary. Apply with a high quality brush, 3/8” nap roller, or airless sprayer. Follow manufacturer's instructions when using spray equipment. Airless spraying - use a 0.017" tip at 1700-2200 psi. Provide adequate ventilation at all times. 

Tinting: Clear B-I-N Advanced can be tinted to off- white and pastel shades by adding no more than 1 oz. universal colorant per gallon. Shake container well before using. 

Application Note: Clear B-I-N Advanced dries to a clear, low sheen finish. When applying over exotic or oily woods and moisture cured urethanes or when top coating with catalyzed finishes, always pre-test in an inconspicuous area to ensure compatibility. 

Dry& Recoat Times: Dry and recoat times are based on 70°F and 50% relative humidity. Allow more time at cooler temperatures. Dries to the touch in 25 minutes and can be recoated in 45 minutes to 1 hour. It is fully cured in 7 days. 

Clean-Up: Clean up spills and paint drips with warm soap and water. Wipe up splatters before they dry. Follow the equipment manufacturer’s directions to clean spray equipment.