SENTINEL PL145 Low Odor Mastic Remover

Application Information (Always follow product label instructions for best results)

DIRECTIONS: Before beginning work, protect all walls, flooring, carpeting, cracks or wood with an absorbent from liquid materials. This will ensure easier clean-up and eliminate potential problems.

STEP 1: Wet the entire adhesive surface with PL145. This may be done by spraying or mopping PL145 over the surface of the mastic. Allow PL145 to soak and penetrate into the mastic for 20 - 30 minutes.

STEP 2: Scrape or squeegee the bulk of the softened or liquefied mastic from the surface with a floor scraper (razor scraper) or floor squeegee.

STEP 3: Reapply PL145 as in step one. Agitate with a short-bristled broom, hand-held or rotating floor scrubber with stripper pads to fully lift and liquefy adhesive residue from the subfloor. The liquid may then removed with absorbent.

STEP 4: Wash and rinse the floor thoroughly with Sentinel 805 and water to ensure a clean surface. Allow to dry a minimum of 24 hours before installing new flooring.