REFINE‑MAXX™ Penetrating Protector

REFINE-MAXX Penetrating Protector is a penetrating, reactive treatment that provides water, oil, and stain repellency for every kind of finished concrete floor. Treated surfaces retain their natural texture and breathability. It improves stain resistance and simplifies maintenance cleaning of interior and exterior, horizontal, and vertical concrete surfaces. Solvent-based and low-odor, this VOC-complaint protective treatment is easily applied with a pump-up sprayer.

Can be applied to any cured concrete, from steel troweled to highly polished.

Do not dilute or alter material. Apply as is. Stir or mix well before use. Once opened, Penetrating Protector must be used immediately.

Coverage rates will change depending on variations in concrete quality, porosity, job site conditions, temperature, and relative humidity. Calculate the target rate by testing a representative section of the prepared surface using the application instructions on the label.

• Steel Troweled Concrete:

1,500 to 3,000 sq ft per gallon

• Mechanically Honed & Polished Concrete:

2,500 to 4,000 sq ft per gallon

• Concrete Floors with Protective Treatment:

4,000 to 5,000 sq ft per gallon

Under typical conditions, treated surfaces are ready for foot traffic when dry to the touch. Floors will gain their stain resistance and water repellency after 24 hours. Before product dries, clean tools and equipment with mineral spirits or equivalent cleaning solvent. Immediately wipe off over-spray from glass, aluminum, or other surfaces.

For best results, treat floors with appropriate REFINE-MAXX densifier before application.