Manufactured for use with the HydraMaster HydraHoe wand, standard upholstery tool, RX20, and Rotary DriMaster. Is equipped with 1/4" fittings.

HydraMaster temperature bypass solenoid.

This high-pressure quick connector is used to connect sections of either the Injectidry Active Hoseline or the Injectidry 1.5" Safety Yellow Blank Hose on Injectidry Wall Systems and the Injectidry Floor Systems.

The MAC vacuum control solenoids work in conjunction with the temperature controller to operate the exhaust diverter actuator. When not functioning properly the actuator won't open and the unit will often under perform in heating. There are two solenoids employed one as a primary and one as a secondary, it's recommended to change both at the same time.

O-ring kit for the HydraMaster valve. Contains three o-rings.