Ameripolish PG‑7K Polishable Grout Coating System

Ameripolish® PG-7K is a fast-setting, polymer-modified, high-strength cement with outstanding bonding properties formulated specifically to fill in small cracks, pinholes, and surface irregularities in concrete floors. It also increases durability, gloss and distinction of image (DOI) on most floors. PG-7K readily accepts Ameripolish® concrete dyes and requires no special polishing procedures.

Ameripolish® PG-7K contains no VOCs.

Preparation

Surface should be clean and free of standing water prior to application. Surface must be free from oil, dust, dirt, grease, laitance, and other bond inhibiting contaminants.

Dilution & Coverage

Mix 2 parts PG-7K Part A – Powder to 1 part Part B – Liquid at 10 lbs to every gallon of Part B. Use drill and egg beater or spiral mixer to mix. Add approximately half the liquid to the powder and mix until creamy and lump free. Add remaining liquid and mix until uniform. Properly mixed product should have the consistency of “buttermilk” or “light cream”.

PG-7K system will typically cover 2,500 sq ft per kit.

Cleanup

Uncured PG-7K cleans up with water. Uncured PG-7K cleans up with water. Cured PG-7K must be removed by mechanical means. PG-7K Part B – Liquid cleans up easily with water, however cured Liquid is extremely difficult to remove.

Storage

• Store upright in safe dry place at 45-100℉(7-38°C)
• Keep liquid from freezing
• Keep powder from moisture, store tightly closed
• Keep out of reach of children
• Do not mix with other chemicals