Concrobium® Mold Control

Get Mold Remediation AND Prevention in One Easy-to-Apply Formula!

Concrobium Mold Control is a dual purpose, non-toxic antimicrobial that can be deployed during the "knock down" phases of restoration projects to control mold spore proliferation.

It can also be applied on restored surfaces for ongoing mold protection.

Concrobium Mold Control dries to form an invisible antimicrobial shield that encapsulates and physically crushes mold spores. The antimicrobial barrier remains on surfaces to provide continuous protection against mold growth.

This product not only works great for mold clean-up and prevention, but it will also help to control musty odors that typically accompany mold problems.

Concrobium Mold Control is EPA registered for use on hard surfaces and fabrics. It can be used on virtually any surface (finished and unfinished), including drywall, lumber, plaster, concrete, siding, shingles, composite decking, metal, marble, tile, grout, fabric, upholstery, furniture, and clothing.

It has a category IV rating, so it contains no harmful chemicals and requires no special handling or personal protective equipment (PPE). It contains no odors, no VOCs, no bleach, and no ammonia. It's the perfect product for use around individuals with chemical sensitivities.

EPA registration number: 82552-1

This ready-to-use solution can be fogged to treat large or inaccessible spaces. It requires zero isolation time.

Application environments:

• Homes
• Businesses
• Cottages
• Automobiles
• RVs
• Boats
• Sporting equipment
• Construction/renovation (pre-treatment of building materials)

Coverage

• Fogging: approximately 1,400 sq ft per gallon
• Spray (Manual or Compression): approximately 500 sq ft per gallon

Concrobium Mold Control is part of the Attic Attack! approach to crawlspace and attic mold remediation. Attic Attack! is consistent with the industry Standard of Care, and can reduce project costs by 65%. Instead of blasting, scraping, or sanding, Attic Attack! relies on Concrobium Mold Control along with Concrobium Mold Stain Remover to effectively eliminate mold and treat tough mold staining.

The Attic Attack! method of mold remediation and control has been shown to deliver results that are as good as, if not better than, traditional sanding procedures. To learn more about Attic Attack!, contact your Jon-Don Restoration Sales Representative at 800-556-6366.

Application
For best results, apply a thin, even coating of Concrobium Mold Control to the surface, and allow to dry thoroughly. Once dry, use product to clean any residual staining. If staining persists, use Concrobium Mold Stain Remover to completely remove all mold staining. Leave a thin, even coating of product on the surface to provide protection against mold.

Application techniques- Roller, brush, rag, garden sprayer. Can also be applied with a cold fogging machine to treat large or inaccessible areas.

Special application instructions
Do not dilute. Do not rinse. Do not use bleach-based products in combination as this may reduce product efficacy.

Coverage
Coverage varies according to surface and application method.

Fogging: approximately 1,400 sq ft. per gallon (the equivalent of a 20' x 20' room with 8 foot ceilings, all surfaces).

Spray (manual or compression sprayer): Approx. 500 sq. ft. per gallon depending on sprayer type and surface absorbency.

Expect reduced coverage on absorbent surfaces such as fabrics, carpet, lumber and unpainted drywall.